Document Type

Article

Rights

Available under a Creative Commons Attribution Non-Commercial Share Alike 4.0 International Licence

Disciplines

2.3 MECHANICAL ENGINEERING

Publication Details

Journal of Materials Science,
Volume 42, Number 14, 5483-5489, DOI: 10.1007/s10853-006-0975-x

Abstract

Magnetorheological Elastomers (MR Elastomers or MREs) are a kind of novel smart material, whose mechanical, electrical, magnetic properties are controllable under applied magnetic fields. They have attracted increasing attentions and broad application prospects. But conventional MREs are limited to wide applications because their MR effects and mechanical performances are not high enough. This paper aims to optimize the fabrication method and to fabricate good natural rubber based MREs with high modulus by investigating the influences of a variety of fabrication conditions on the MREs performances, such as matrix type, external magnetic flux density, and temperature, plasticizer and iron particles. Among these factors, the content of iron particles plays a most important contribution in shear modulus. When the iron particle weight fraction is 80% and the external magnetic flux density is 1 T, the field-induced increment of shear modulus reaches 3.6MPa, and the relative MR effect is 133%. If the iron weight fraction increases to 90%, the field-induced increment of shear modulus is 4.5MPa. This result has exceeded the best report in the literatures researching the MREs on the same kind of matrix. The dynamic performances of MREs were also experimentally characterized by using a modified Dynamic Mechanical Analyzer (DMA) system. The effects of strain amplitude and driving frequency on viscoelastic properties of MREs were analyzed.

DOI

10.1007/s10853-006-0975-x


Share

COinS